Vector VEC061 Manual do Proprietário

VEC061OWNER’S MANUAL & WARRANTY INFORMATIONTHIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDINGSAFETY, OPERATION, MAINTENANCE AND STORAGE OF THIS

1010WARNING - Do not use the inverter near flammable materials or in any locations that may accumulate flammable fumes or gases.5. OPERATING TIPS5.1

11The inverter draws less than 0.3 ampere from the battery when it is notsupplying power to a load. In most instances, the inverter can be left connec

1212NOTE: It is normal for the alarm to sound while the unit is being connectedto, or disconnected from, the power source. This is not indicative of a

138. TROUBLESHOOTING GUIDE:TABLE 1 - INVERTER POWER SWITCH TURNED ONTROUBLE/ INDICATION POSSIBLE CAUSE SUGGESTED REMEDYNo AC output – DC input below

14149. FUSE REPLACEMENTIf external fuses blow, (or breakers trip), then there is a short or overloadin the DC wiring. Find and fix the problem before

1511. WARRANTY2/4 YEAR GOLD SEAL LIMITED WARRANTY PROGRAMThis limited warranty program is the only one that applies to this product,and it sets forth

© 2004 VECTOR MANUFACTURING, Ltd.FT. LAUDERDALE, FL 33312 MADE IN CHINALIMITATIONS: This warranty does not cover accessories, bulbs, fuses andbatterie

22IMPORTANT SAFETY INSTRUCTIONS To ensure reliable service, your power inverter must be installed and usedproperly. Please read the installation and o

3CONTENTS1. INTRODUCTION ...42. CONTROLS, INDICATORS AND CONNECTORS ...4,53. HOW

441.INTRODUCTIONYour new Vector MAXX350SST inverter is one in a series of the most advanced DC to AC inverters available today. With proper care and a

5Outlets accommodate either two or three pin AC plugs. An On/Off Switchturns the inverter circuitry On and Off. The switch is used to force reset ofin

663.2 THE MAXX 350SST OUTPUT WAVEFORMThe AC output waveform of the MAXX350SST is known as “modified sinewave”. It is a waveform that has characterist

7CAUTION: The MAXX 350SST must be connected only to batteries witha nominal output voltage of 12 volts. The unit will not operate from a 6 volt batter

884. Check to be sure that all connections between battery clips andterminals are secure.Direct Hardwiring to Power Source:Use #10 AWG wire if the in

9into the AC receptacle(s). The green LED indicator lights to indicate that theinverter is functioning. Make sure the combined load requirement of you