Vector MAXXSST 2200 Manual do Proprietário descarregar pdf (Página 2)

PROBLEM: LOW POWER OUTPUT

POSSIBLE CAUSE

SUGGESTED SOLUTION

Inadequate power or Clean and reconnect cables and

excessive voltage drop. reduce input cable length.Use

correct gauge and length wire.

9.0 MAINTENANCE

The MAXXSST

™

2200 inverter requires minimal maintenance. However, for

optimum performance, perform the following as required.

1. Turn OFF the converter using the front panel ON/OFF switch.

2. Disconnect the inverter by removing the DC power fuse.

3. Check and tighten all electrical connections including the ground.

4. Using a non-metallic vacuum cleaner hose, vacuum the fan area and other

air slots.

5. Clean any dirt and dust from the outside of the unit with a damp cloth.

6. Reconnect the fuse and resume operation

10.0 APPENDIX A CABLE REQUIREMENTS

VEC085 is a two-conductor, cable set 6 feet long with fuse holder attached

and ANL500 fuse. This cable set can be used with the VEC051SST and

VEC055SST power inverters.

Other cables may be used with this 2200 watt inverter. If you are purchasing

wire from an electrical equipment distributor then use the table below as a guide.

The table gives total length (twice the cable length as distance between inverter

and DC source).

IMPORT

ANT SAFETY INFORMATION

To ensure reliable service, your power inverter must be installed and used properly.

Please read the installation and operating instructions thoroughly prior to installation

and use. Pay particular attention to the WARNING and CAUTION statements in

this manual. The CAUTION statements advise against certain conditions and

practices that may result in damage to your inverter. The WARNING statements

identify conditions or practices that may result in personal injury.

READ ALL INSTRUCTIONS BEFORE USING THIS POWER INVERTER

WARNINGS

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, EXPLOSION OR INJURY:

• Do not connect to AC distribution wiring

• Remove appliance plug from outlet strip or turn off inverter before

working on the appliance

• DO NOT locate inverters in an area, room or compartment where

explosive or flammable fumes might be present

• Unplug appliances when servicing

• KEEP AWAY FROM CHILDREN—THIS IS NOT A TOY

Multiple outlet power strips with switches and circuit breakers only interrupt

power to the “hot” receptacle terminals. The “neutral” terminals remain

powered with respect to the “ground” terminals

CAUTIONS

• NO USER-SERVICEABLE COMPONENTS INSIDE. OPENING UNIT

WILL VOID WARRANTY

• Do not use with positive ground electrical systems (the majority of

modern automobiles, RVs, and trucks and boats are negative ground)

Reverse polarity connection will result in a blown fuse and may cause

permanent damage to the inverter and will void the warranty

•Grounding the Neutral will cause the inverter to shut down

• Do not operate this inverter if it is wet

•Do not install in engine compartment - install in a well ventilated area

•Not approved for use in conjunction with medical equipment

IMPORTANT CABLE INFORMATION

Substantial power loss and reduced battery operating time results from invert-

ers installed with cables that are not able to supply full power. Symptoms of

low battery power can result from cables that are either excessively long or an

insufficient gauge. The installer/operator should be especially aware of the

requirements to maintain secure, electrical connections. Cable insulation and

ampacity (ampere capacity) must be the appropriate type for the environment. If

you want to purchase a prepared cable and fuse set contact Technical Support at

(954) 584-4446 or toll free at (866) 584-5504, ext. 19.

CABLE #2 AWG #1 AWG 00 (2/0) 0000 (4/0)

GAUGE AWG AWG

TOTAL 6 Ft. 10 Ft. 14 Ft. 20 Ft.

LENGTH

*DISTANCE 3 Ft. 5 Ft. 7 Ft. 10 Ft.

FUSE ANL500 ANL500 ANL500 ANL500

* DISTANCE from battery to inverter (1/2 cable length)

1 2 3 4 5 6 7 ... 15 16

Comentários a estes Manuais

Sem comentários

Vector MAXXSST 2200 Manual do Proprietário Página 2

Comentários a estes Manuais

Manuais e produtos relacionados com Adaptadores e conversores de corrente Vector MAXXSST 2200