Vector MAXXSST 2200 Manual do Proprietário descarregar pdf (Página 5)

1.1 BASIC TOUR OF THE

MAXXSST

™

2200 INVERTER

AC power is supplied via two standard North American grounded,household-type

receptacles (U-ground) as shown in FIGURE 1 (THE FRONT PANEL). This allows the

connection and operation of most 110 VAC-powered electrical and/or electronic

appliances using a standard plug. Each U-ground receptacle is separately protected

by a 15-amp circuit breaker. For heavy duty applications, appliances or electrical

distribution circuits can be wired directly to the High Output Terminal Block. The terminal

block wires are color-coded: black-hot; white-neutral and green-ground. Note that

the High Output Terminal Block MUST be wired to a user-supplied dual ganged

25 Ampere, 110 volt AC circuit breaker if the terminal block is used. For safety

reasons, the circuit breaker can be a Ground Fault Interrupter (GFI) breaker if the

distribution wiring AC outlets are located near plumbing or where unsupervised

small children will have access to them.

Figure 1. Front Panel.

The rest of the front panel items are: One vertically mounted LED bar voltmeter that

indicates battery voltage measured at the inverter’s DC terminals. One vertically

mounted LED bar ammeter that indicates battery current drawn by just the inverter.

An ON/OFF switch that turns off the inverter circuitry, the cooling fan and AC out-

put. A high-temp LED indicator and Overload LED indicator. If either of these light,

the inverter will automatically shut down until the condition improves.

FIGURE 2 shows the back panel DC connectors and fan locations. Note that

the fan only operates when the inverter temperature rises. It shuts off when cooling

is not required.

GROUNDING

TERMINAL

Figure 2. Back Panel.

6.0 SPECIFICATIONS

Maximum Continuous Power . . . . . . . . . . . . . . . . . . . . . . . . .2200 Watts

Surge Capacity (Peak Power) . . . . . . . . . . . . . . . . . . . . . . . . 4500 Watts

No Load Current Draw (switch ON) . . . . . . . . . . . . . . . . . . . . . 1.0 amps

Max. Efficiency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . approx. 90%

Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0-15 VDC

Output Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 VAC 60 Hz

Low Voltage Alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10.6 Volts

Low Voltage Shutdown . . . . . . . . . . . . . . . . . . . . . . 10.0 Volts Auto Reset

Thermal Shutdown . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Auto Reset

Wave Form . . . . . . . . . . . . . . . . . . . . . . . . Modified Sine Wave (MSW)

Front Panel Circuit Breakers . . . . . . . . . . . . . . . . . . . . . . . . . Dual 15-amp

Output Receptacles . . . . . . . . . . . . . . . . . . . . . Two U-ground, 15 ampere,

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .North American Standard

High Output Terminal Block . . . . . Supplies up to 20 amps to screw terminals

Power Transistor Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . MOSFET

Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23.8 lbs. (10.8 kg)

Length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20.8 in. (53 cm)

Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7.8 in. (20 cm)

Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.30 in. (16 cm)

7.0 SERVICE & PARTS

For service on the MAXXSST

™

2200, or to purchase a prepared cable set, fuse,

fuse holder, and terminal connectors required for installation, contact the Customer

Service Department at: VECTOR Manufacturing, Ltd. 4140 S.W. 28th Way, Fort

Lauderdale, FL 33312 Tel. (954) 584-4446 • Fax (954) 584-5556

8.0 TROUBLESHOOTING

8.1 Common Problems:

Power Tools and Microwave Ovens Won’t Start

Read the information panel on each power tool carefully to accurately determine

the tool’s input wattage. The MAXXSST

™

2200 wattage output is sufficient to

operate most power tools and microwave ovens but remember that the power

needed to start the power tool may be as much as 2 to 6 times its continuous

wattage requirements.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Comentários a estes Manuais

Sem comentários

Vector MAXXSST 2200 Manual do Proprietário Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Adaptadores e conversores de corrente Vector MAXXSST 2200